อุปกรณ์วัด Conductivity/TDS (Pronto EC Meter 10 µS/cm resolution)
Pronto EC Meter
10 µS/cm resolution
- Water resistant
- Continuous EC monitoring
- Visual LED alarms
This water resistant conductivity meter is the result of customer requests for accurate, affordable process monitoring with low maintenance.
HI 983303-01 is supplied with a direct 2-pin probe and 2 m (6.6′) cable with a ½” thread for flow-thru mounting. The probe has a temperature sensor to automatically compensate against temperature changes from 5 to 50°C (41 to 122°F) with a β of 2% per degree.
In the measurement mode, a red LED will warn the user in the event the reading is outside of the alarm interval. A front trimmer allows manual calibration at 1 point. The electrical circuitry is tightly sealed inside the water resistant enclosure. This meter can be installed anywhere quickly and easily with the casings molded eye. The casing has been specially designed to sit out of the way and will not roll off a table. The 12 VDC power supply allows continuous monitoring over extended periods of time.
HI 983303-01 (115V) and HI 983303-02 (230V) is supplied with HI 7634/2 EC/TDS probe, calibration screwdriver, 12 VDC adapter and instructions.
|Range||0 to 1990 µS/cm|
|Calibration||manual, 1 point through trimmer|
|Calibration Solution||HI 70031|
|Temperature Compensation||automatic, 5 to 50°C (41 to 122°F) with ß=2%/°C|
|Setpoint||200 to 1600 µS/cm|
|Alarm||red LED blinks when measured value differs from set point more than 100 µS/cm|
|Probe||HI 7634/2 with 2 m (6.6′) cable and ½” thread
|Power Supply||12 Vdc power adapter (included)|
|Environment||0 to 50°C (32 to 122°F); RH max 100%|
|Dimensions||86 x 110 x 43 mm (3.4 x 4.3 x 1.7″)|
|Weight||215 g (7.6 oz.)|